Installation Instructions
1.
Insert each connector label-side up into its respective pull cover, and then close the cover:
2.
Unpack the AOC Cable Pulling Eye:
The HyperLight Pull Sleeve consists of three parts, the Pull Loop, the Pull Cord, and the Flexible
Sleeving. The Pull Loop (1), located at the left-most side of the above image, is where the
installer will attach a cord used to pull the cable bundle. The Pull Cord (2) is wrapped around
the cable(s) to be pulled, and serves as a strength member that protects the cable(s) from
undue tension. The Flexible Sleeving (3) covers and protects the cable bundle from getting
snagged on conduit edges or other cables. This sleeving is made of flexible plastic netting
that easily expands and contracts as needed.
3.
In order to access the Pull Cord, the Pull Sleeve must be collapsed and reversed. To do
this, grab the heat-shrink tubing at the base of the Pull Loop and press inward against the
sleeve, while pushing the sleeve against the loop. The sleeve will start to collapse, with
the loop inside the sleeve:
3
2
1
2
