Dutchess JN, General Safety, Installation, Instruction &?Parts Manual, Page: 13 / 39

Figure 19
Figure 20
Install the screws into the divider through the holes in the
top plate. Tighten the screws with the flat blade screw
driver (Fig. 21).
Figure 21
Wash the outside ring in hot soapy water, rinse and dry. Do
not drop or bump this ring as this will cause nicks or
damage to ring.
Wash the pallets using hot soapy water, rinse and dry. A soft
brush will assist in cleaning the pallets. Never use solvents
or metal scraper on pallets.
HEAD CLEANING
CAUTION!
Do not use solvents; use only mild soap and water, or
you may place entire head in dishwasher. Use care
that washer sprayers will not hit head assembly as
damage could occur to head and/or dishwasher.
For the best cleaning results, remove the ring and head
assembly, (see instructions pages 5-7) and place on
table. Remove divider from head assembly by removing
the screws with a flat blade screwdriver through the holes
in the upper plate (Fig. 17). Next, lift head by the handles.
The divider will remain on the table (Fig. 18). Remove the
screws and set aside for re-assembly.
Figure 17
Figure 18
The divider may then be washed in hot water with soap,
rinsed and dried -
avoid bumping dividers on solid
objects as this will cause damage.
The remaining head assembly may be washed in hot
water with soap, rinsed and allowed to air dry. Air drying
is necessary so components will cool and allow for proper
operation. To reassemble the divider into the head, place
the head upside down on a table, align the longer dividers
in the slots with the screw holes below. Align all the
dividers with the head (Fig 19). Slip the divider into place,
adjust the screw slots (Fig. 20). While holding the divider
in place, turn the entire head right side up and set on
bench.
8