5
Parts & Operations Manual
Integra TX / LA / UHS
Getting Started
IMPORTANT: Do not use on wet surfaces. Do not expose to rain. Store indoors.
Your polisher has been assembled to allow you to operate the machine within a few minutes after removal from the shipping
carton. There are several procedures to follow that will ensure a safe and proper start-up.
1.
Check the machine over completely after removal from the carton. Any damage or missing pieces must be reported
to your sales representative immediately.
2.
Dual Speed Models:
Each unit requires a drive pad and floor pad. Before plugging the unit into an AC outlet, lay the
machine back down on its wheels and handle and install the drive pad onto the motor gearbox by engaging it into the
hub and turning it counter-clockwise (as viewed from the bottom). The drive pad must seat fully. Center the floor pad
and press lightly to allow the drive pad to grip it.
UHS Models:
Drive pad and floor pads are already installed before shipping. The floor pad may be replaced by turning
the “Center-Lock” counter clockwise to remove. Replace pad by centering it on drive pad and re-install “Center-Lok”.
3.
Return the unit to the upright position and plug it into a grounded 115V AC wall outlet with a rating no higher than
15 amps
.
Dual Speed Models
UHS Models
Speed Selection Switch
Trigger
Safety Lever
AMP Meter
Handle Adjustment Lever
75’ 600V Cord with
Hospital Grade Plug
50’ 600V Cord with
Hospital Grade Plug
Cord Hook
Molded Poly Chassis
Vinyl Bumper Pad
Adjustable
Support Wheel
Dust Skirt
Dust Collector Bag
5” Non-Marking Wheels
Pad