Dustbane 19376, Operation Manual

Page: 11 / 40

11 Parts & Operations Manual Micro-5
! INFORMATION: Pressing the brush control button also has the effect of automatically enabling the
suction and detergent solution flow functions, which can then be controlled and adjusted by way of the
respective single buttons on the console.
• Suction control button (fig. 15, ref. 3): switches on (“Led ON”) and switches off (“Led OFF”)
the suction motor, which generates the vacuum needed to dry the floor after scrubbing.
The motor comes into operation only when activated by way of the “Brush control lever”.
• Detergent flow button (fig.15, ref. 5): enables (Led ON) and disables (Led OFF) the flow of
detergent solution, with three levels of delivery available. Flow is enabled only with the
brush in operation.
• ECO button (fig.15, ref. 4): enables (Led ON) and disables (Led OFF) ECO operating mode.
! INFORMATION: In ECO operating mode, the power of the brush motor and suction motor is reduced automatically and the flow of
detergent solution defaults to delivery level 1.
Working
• Press the main switch (fig. 16, ref. 1).
• Press the brush button or the ECO button (fig. 17, ref. 1), in addition to activating the brush,
this will also enable the vacuum function and the flow of detergent solution.
• Lower the squeegee by operating the lever (fig. 16, ref. 2).
• Depress the brush control lever (fig. 16, ref. 3).
• Begin working.
! INFORMATION: This machine can dry the floor moving both forward and in reverse.
To operate the drying function in reverse, pull the lever upwards (fig. 18, ref. 1)
• When work is in progress, check the thoroughness of the wash and regulate the flow of
detergent solution accordingly, with the relative button (fig. 17, ref. 3).
! INFORMATION: Check periodically that the detergent solution is reaching the brush, and take care to fill
the tank when empty.
! WARNING: Should the red Led of the battery charge indicator light up when work is in progress, this
means that the battery is almost out of power, and after a few seconds the brush and vacuum functions
will shut off automatically. Proceed to recharge the battery, referring to the section “Battery: preparation /
installation / recharging”.
In cases where floors are soiled with particularly stubborn dirt, scrubbing and drying operations can be performed in two separate
stages. Prewashing with brushes or pads:
• Raise the squeegee by operating the lever (fig. 16, ref. 2).
• Press the main switch (fig. 16, ref. 1).
• Press the brush control button (fig. 17, ref. 1).
• Switch off the vacuum function by pressing the suction control button (fig. 17, ref. 2).
• Depress the brush control lever (fig. 16, ref. 3).
• When scrubbing particularly dirty areas, give the detergent sufficient time to perform its chemical action of detaching
and suspending the dirt in the film of water, and allow the brushes time to exert an effective mechanical action.