Duruxx DRX2, Operator'S Manual

Page: 65 / 82

65
Wipe out any oil spillage on engine. Change gasket on oil drain plug. Clean
gasket area on engine and oil drain plug then reinstall plug. Refill engine at
the proper level with the recommended oil. Refer to SPECIFICATIONS for
capacity. Start engine and let idle for a few minutes. Ensure oil filter area and
oil drain plug areas are not leaking. Stop engine. Wait a while to allow oil to
flow down to crankcase then check oil level. Refill as necessary.
Dispose of oil as per your local environmental regulations.
Oil Strainer Replacement
The oil strainer must be cleaned every 200 hours or every 2 years or every
6000 km. Contact an authorized Duruxx DRX2 dealer.
Coolant Replacement
WARNING
To prevent burning yourself, do not remove the radiator cap or loosen
the coolant drain plug if the engine is hot.
Fill the coolant, Open the access panel and remove reservoir cap.
Remove the right engine cover. Unscrew the coolant drain plug and drain the
coolant into a suitable container. Replace coolant, Disconnect the engine
temperature sensor connectors, then unscrew the bleeding screw on the top
of thermostat housing. Drain the system completely and reinstall the coolant
drain plug. Fill the radiator until the coolant comes out by the thermostat
housing hole. Install the bleeding screw then remove the hose pincher.
Complete the radiator filling. Check the level in the coolant reservoir and refill
if necessary. Run engine at idle with the radiator cap off. Slowly add coolant if
necessary. At this point, wait until engine reaches normal operating temperature.
Depress the throttle lever two or three times; then add coolant if required. Install
radiator cap. Inspect all connections for leaks and check coolant level in the
reservoir.
Reservoir cap