Duruxx DRX2, Operator'S Manual

Page: 57 / 82

56
NOTICE:
Check level frequently and refill
if necessary. Do not overfill.
Operating the engine/
transmission with an improper
level may severely damage
engine/transmission. Wipe off
any spillage.
RH SIDE OF ENGINE
With vehicle on a level surface
and engine cold, not running,
check the oil level as follows:
1. Unscrew dipstick then remove
it and wipe clean.
2. Reinstall dipstick, screw in it
completely.
3. Remove and check oil level. It
should be near or equal to the
upper mark.
4. To add oil, remove dipstick.
Place a funnel into the dipstick tube
and fill up with the recommended oil
to upper mark. Do not overfill.
5. Properly tighten dipstick
Engine Coolant
Recommended Coolant
Remove the reservoir cap. Always use
ethylene-glycol antifreeze containing
corrosion inhibitors specifically for
internal combustion aluminum engines.
Cooling system must be filled with
water and antifreeze solution (50%
water, 50% antifreeze).
Coolant Level
Check coolant level with engine
cold. Never add coolant in cooling
system when engine is hot. With
vehicle on a level surface, liquid
should be between MIN. and MAX.
level marks of coolant reservoir.
NOTE:
When checking level at temperature
lower than 20°C (68°F), it may be
slightly lower than MIN mark. Add
coolant up to MAX. Mark if required.
Use a funnel to avoid spillage. Do
not overfill. Properly reinstall and
tighten filler cap and reinstall
access panel. If the coolant is
added in the coolant reservoir,
check the level in the radiator too.
Add coolant if necessary.
Oil Gauge
Min
Max