Duronic BPM150, Manual

Page: 25 / 134

25
Table 2 Guidance and MANUFACTURER’s declaration – electromagnetic
IMMUNITY – for all ME EQUIPMENT and ME SYSTEMS
Guidance and manufacturer’s declaration – electromagnetic immunity
The device is intended for use in the electromagnetic environment speci
fi
ed below.
The customer or the user of the device should assure that it is used in such an
environment
IMMUNITY test
Electrostatic
discharge
(ESD)
IEC 61000-4-2
Electrical fast
transient/burst
IEC 61000-4-4
Voltage dips,
short
interruptions
and voltage
variations on
power supply
input lines
IEC 61000-
4-11
Power
frequency
(50/60Hz)
magneti
c fi
eld
IEC 61000-4-8
3A/m 3A/m
±6 kV contact
±8 kV air
±2 kV for power
supply lines ±1 kV
for input/output
lines
<5% UT
(>95% dip in UT)
for 0.5 cycle
40% UT
(60% dip in UT )
for 5 cycles
70% UT
(30% dip in UT )
for 25 cycles
<5% UT
(>95% dip in UT )
for 5 s
<5% UT
(>95% dip in UT)
for 0.5 cycle
40% UT
(60% dip in UT )
for 5 cycles
70% UT
(30% dip in UT )
for 25 cycles
<5% UT
(>95% dip in UT )
for 5 s
±6 kV contact
±8 kV air
±2 kV line(s) to
line(s)
Floors should be wood,
concrete or ceramic tile. If
fl
oors are covered with
synthetic material, the
relative humidity should be
at least 30%.
Mains power quality should
be that of a typical
commercial or hospital
environment.
Mains power quality should
be that of a typical
commercial or hospital
environment. If the user of
the device requires
continued operation during
power mains interruptions,
it is recommended that the
device be powered from an
uninterruptible power supply
or a battery.
Power frequency magnetic
fi elds should be at levels
characteristic of a typical
location in a typical
commercial or hospital
environment.
NOTE UT is the a.c. mains voltage prior to application of the test level.
IEC 60601 test level Compliance level
Electromagnetic
environment - guidance