2
DM4P10K
July 2018
READ THIS MANUAL THOROUGHLY BEFORE INSTALLING, OPERATING, OR MAINTAINING
THIS LIFT. WHEN DONE WITH INSTALLATION BE SURE TO RETURN DOCUMENTS TO
PACKAGE AND GIVE ALL MATERIALS TO LIFT OWNER/OPERATOR. WHEN INSTALLATION
IS COMPLETE BE SURE TO RUN LIFT UP AND DOWN A FEW CYCLES WITH AND WITHOUT
“TYPICAL” VEHICLE LOADED ON LIFT.
TABLE OF CONTENTS
• IMPORTANT INFORMATION
• OWNER / EMPLOYER RESPONSIBILITY
• LIFT SPECIFICATIONS
• FLOOR PLAN LAYOUT
• TOOLS REQUIRED
• SELECTING SITE
• MAIN COMPONENTS & ACCESSORY IDENTIFICATION
• INSTALLATION INSTRUCTIONS
• CASTER KIT ASSEMBLY / INSTALLATION
• FOUNDATION & ANCHORING REQUIREMENTS
• SAFETY INSTRUCTIONS & PROCEDURES
• OPERATION INSTRUCTIONS
• PREVENTIVE MAINTENANCE SCHEDULE
• TROUBLESHOOTING
• LATCH & CABLE INSPECTION / ADJUSTMENTS
• EXPLODED VIEWS
• PARTS LIST
• WARRANTY POLICY
IMPORTANT INFORMATION
1. Always inspect the lift for damage and make note of any damage on the bill of lading.
2. In case of freight damage, call the truck line immediately and report the damage as a freight
claim.
3. IMPORTANT! Make sure you have extra help or heavy duty lifting equipment when unloading
and assembling the lift.
4. Please read the safety procedures and operating instructions in this manual before operating
lift. Keep this manual near lift at all times. Make sure all operators read this manual.
5. IMPORTANT! Are you installing in a level location? (Lift must be anchored in place if slope is
greater than 1/8” per foot.)
6. Make sure you have enough room to install the lock rods. You will need at least 9
’ of clearance
from the opposite end of the power unit end of the lift and 6
’ at the power unit end. The power
unit may be installed on the driver front or the passenger rear corner.
7. Never raise a car until you have double checked all bolts, nuts and hose fittings.
8. Always lower the lift to locks before going under the vehicle or storing another vehicle
underneath lift.
9. Never allow anyone to go under the lift when raising or lowering.
