DURKOPP ADLER 991-210-10 Series, Service Instructions Manual

Page: 60 / 150

Short thread cutter (KFA)
58 Service Instructions 911-210-10 - 00.0 - 06/2020
11.5 Adjusting the cutoff position
Fig. 44: Adjusting the cutoff position
Proper setting
The default is that the cutoff position is “thread lever at top dead center”.
When the machine is at the position “thread lever at top dead center”,
the control cam (1) is at its highest point.
To adjust the cutoff position:
1. Press down the hand crank and turn it to the position "thread lever at
top dead center".
2. Loosen the threaded pins (2).
3. Turn the control cam (1) correspondingly.
4. Tighten the threaded pins (2).
(1) - Control cam (2) - Threaded pins
①
②