2.3
Adjusting the levers on the rear feed shaft
Rule:
When setting the stitch length" 0“, the feed clutch should be in the
middle range of the work limit settings.
–
Set the stitch length to “0”.
–
Loosen screw (1).
–
Set the lower feed dog in the middle between the dead centre
points of its motion in the throat plate.
–
Tighten screw (1).
–
Loosen screws (2).
–
Screw out the screw on the feed clutch (4). Push the needle (3) into
this opening. Turn the clutch (4) with your hand until the needle (3)
is 5 mm into the hole. The rule is then fulfilled.
–
Tighten screw (1).
Caution: Risk of Injury!
Turn the main switch off.
Only carry out this lever adjustment when the machine is turned off.
ATTENTION: Danger of breakage!
With large stitch lengths, it is possible that parts within the clutch will
collide if the middle working range of the clutch is not maintained.
7
GB
1
3
4
2
