DURKOPP ADLER 540 - 100, Operating Instructions Manual

Page: 13 / 49

4.1.4 Submenu for the thread monitor configuration
No. Parameter name Symbol Range Description
T1.4.1 Repair mode A, B, C Selection of the repair mode to be
used.
T1.4.2 Needle thread monitor 0 … 10 Number of stitches not registered by
the thread breakage monitor before
an error message is displayed.
At the
value 0 the thread breakage
monitor is switched off.
Description repair modes T1.4.1
Method A:
The buttonhole has to be unstitched and sewn again.
–
After switching the automate on again the sewing basket lifts and
releases the material.
The automate is ready for a new sewing cycle.
Method B:
The buttonhole is completely stitched around anew.
–
After switching the automate on again the sewing basket remains
lowered. The material under the sewing basket remains in its
position.
–
Step the pedal forward (2nd step). The sewing cycle is started.
–
After the sewing cycle the automate runs in reference position and
the sewing basket is lifted.
–
The material can be taken out.
The automate is ready for a new sewing cycle.
Method C:
The buttonhole is continued to be sewn from the recognized point of
thread breakage.
–
After switching the automate on again the sewing basket remains
lowered. The material under the sewing basket remains in its
position.
–
Step the pedal forward (2nd step). The sewing basket moves to the
recognized point of thread breakage with the material.
–
With the cursor keys
ñ
and
ò
you can move - not sewing - to the
position to continue the sewing cycle.
–
Step the pedal forward (2nd step). The sewing cycle is started.
–
After the sewing cycle the automate runs in reference position and
the sewing basket is lifted.
–
The material can be taken out.
The automate is ready for a new sewing cycle.
9
3