en
About the mounting instructions
These mounting instructions come as part of the Duravit
product and should be read carefully prior to installation.
Target readership and qualifications
The product and associated water connection should only be
installed by qualified plumbers. The electrical installation
should only be carried out by qualified electricians.
Explanation of the signal words and symbols
DANGER
Indicates a hazardous situation which,
if not avoided, will result in death or
serious injury.
WARNING
Indicates a hazardous situation which,
if not avoided, could result in death or
serious injury.
CAUTION
Indicates a hazardous situation which,
if not avoided, could result in minor
or moderate injury.
NOTICE
Is used to address practices not
related to physical injury.
Link to the
Electrical Installation
section
Link to the
installation information
in this section
Link to other
instructions
Link to the
Water Installation
section
Inspection (e.g. for scratches)
Do not kink hose
Check for leaks and leak-tightness
Risk of fatal electric shock!
> The product has to be correctly earthed. Do NOT operate the
product without proper grounding.
> Do NOT remove individual components.
> Connect the product only to the specified power supply.
> NEVER touch the power supply cable with wet hands.
> When working on electric components, disconnect the power
supply.
> If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons
in order to avoid a hazard.
> Check rated power and choose cable cross section
accordingly.
Product and/or property damage
> Do NOT install the product in a room exposed to excessive
moisture. Ensure sufficient ventilation to avoid condensation
in electric components.
> Only use the parts in the installation kit to avoid
malfunctions.
> Do NOT use attachments not recommended by Duravit.
Freezing water
If the room temperature is too low, this can cause damage to
the product.
> Do NOT install the product in rooms where there is a danger
of frost. The room temperature must not be less than
4 °C (39 °F).
Condensation
Condensation may occur when moving from a cold location to a
warm location and can cause damage to the product.
> Leave the unit switched off for a few hours if it has been
moved from a cold location to a warm location.
Standards and regulations
The breach of local and country-specific regulations and
standards can cause damage to the product and/or property
damage.
> Local installation regulations, country-specific standards
and the Low Voltage Directives shall be observed at all times.
8
57313_Mounting_SeWa_Starckf_EU/20.01.2
Summary of Contents for SensoWash Starck f
