DURAVIT SensoWash 212051, Mounting Instructions

Page: 7 / 40

fren
1. About this document
All documents related to this product and further
information are available online:
> Access online documents at qr.duravit.com or
www.duravit.com.
> Scan the QR code on the packaging label/product
label.
2. Safety
2.1 Purpose of the document
The instructions are part of the Duravit product. Failure
to follow the instructions may result in personal injury,
product damage and/or property damage.
> Read and follow the instructions.
> Keep this document and pass it on to subsequent
users.
We reserve the right to make technical improvements
and visual changes to the products illustrated.
2.2 Target readership and qualifications
All work associated with the installation may only be
undertaken by plumbers.
• Plumbers are persons with the appropriate technical
training, knowledge and experience so that they can
recognise and avoid dangers and risks that may arise
during the installation in the sanitary area.
• Plumbers are qualified to select and use suitable
protective equipment.
• Plumbers are familiar with and observe the installation
regulations of local utility companies and country-
specific standards.
The electrical installation may only be carried out by an
electrician.
• Electricians are persons with the appropriate technical
training, knowledge and experience so that they can
recognise and avoid dangers and risks that may be
caused by the electricity.
• Electricians are qualified to select and use suitable
protective equipment.
• Electricians are familiar with and observe the
installation regulations of local utility companies and
country-specific standards.
2.3 Electrical safety
Risk of fatal injury caused by electric shock
Contact with electricity can lead to a fatal electric shock.
General precautions
> Connect the product only to the specified power supply.
> The product must be earthed. Do NOT operate the
product without proper grounding.
> Disconnect electrical components from the power
supply before the installation.
> Prevent the power supply from being switched on
accidentally.
> Check that all components are de-energised.
> Never touch the power supply cable with wet hands.
> If the supply cord on this unit is damaged, it must be
replaced by the manufacturer, the service agent or
similarly qualified persons in order to avoid a hazard.
> Do NOT remove individual components.
Lay a permanent power supply line which must be on a
separate circuit:
> Observe the position of the electrical connection.
> Leave at least 800 mm (31 ½") of feed cable exposed.
> Confirm that the grounding wire is 10 mm (⅜") longer
than the L and N wire.
> Check rating label for rated power and choose
cable cross section according to local standards and
regulations 1 – 2.5 mm
2
(17 – 14 AWG).
Install a circuit breaker
> Means for disconnection must be incorporated in the
fixed wiring in accordance with the wiring rules and
having a contact separation in all poles that provide
full disconnection under overvoltage category III
conditions.
Install residual current device (RCD)
The product itself does not have electrical leakage
protection function. The product must be supplied
through a RCD not exceeding max. 30 mA.
Avoid condensation
> Do NOT install the product in a room exposed to
excessive moisture. Ensure sufficient ventilation to
avoid condensation in electric components.
> When the product is brought from a cold location to a
warm one, leave the unit switched off for a few hours
to avoid condensation.
54040_MI_SensoWash_1pWC
7