MK4C CLEAR ROOF PANEL (Optional)
12
Step 1:
Leave a gap where the Clear Panel is to be fitted. Position the next Roof Sheet. Ensure it overlaps correctly, then rivet togeth-
er, one rivet in the centre and one approximately 600 mm down from the centre on both sides. Fit remaining Roof Sheets,
overlapping and riveting as you go. Nail on first Roof Sheet (refer step 3 on page 11).
Step 2:
Where the Clear Roof Panel is to be positioned, nail a 45x45mm Bevelled Edge Support on each side of the Ridge Beam.
fig.
1)
Step 3:
Position Clear Roof Panel and Flat Roof Sheet (or second Clear Panel). The Flat Roof Sheet underlaps one sheet and overlaps
the other. The Clear Roof Panel OVERLAPS both Roof Sheets. Ensure sheet joins are flush at the outside edge then rivet flat
sheets to pressed sheets. Two rivets per join. Centralise Roof at the other end and screw in place.
Step 4:
Ensure Ridge Beam is straight, then nail the Clear Panel and Flat Roof Sheet (or second Clear Panel) to 45x45mm Bevelled
Edge Supports using one 30mm Clout per Pan. Run two generous beads of Silicone on the under side of the Pressed Capping
Sheet. Position Pressed Capping Sheet on Ridge Beam and screw in place using three 50mm Roofing Screws. Screw one
50mm Roofing Screw into Ridge Beam through each rib on overlap, (one screw per sheet).
Step 5:
Continue to fasten roof sheets as per step 4 on previous page (pg11)
Note:
When Screwing through the Clear Panel, pre
-
drill a 6mm hole.
TOP PLATE
JACK STUD
RIDGE BEAM
45 x 45 BEVEL
75mm NAIL
SILICONE
30mm CLOUT
PRESSED
ROOFING SCREW
PRESSED
CLEAR ROOF
FLAT ROOF
Fig.1
Note:
MK2 shown
Summary of Contents for MK4C
Page 1: ...Quality Built In ASSEMBLY INSTRUCTIONS MK4C BASE SIZE 4210mm x 4210mm ...
Page 4: ......
Page 17: ......
Page 18: ......
