13
MK4C DOORS
Step 2:
Position right hand Door Track (D107) on front wall
up against underside of Roof, with left hand end
hard against the Centre Door Stop. Pre
-
drill hole in
centre and rivet in place. Remove ALL drill filings
Step 3:
Hang right hand door in Door Track. At the right
hand end of Door Track, adjust up or down so that
the Door hangs parallel with shed. Fit one rivet at
right hand end to hold in place.
Step 4:
Position left hand Door Track (C107). Follow Steps 2 and
3 to hang left hand Door. Where Door Tracks meet in the
centre, adjust up and down so that the Doors fit snuggly
together, then rivet in place. Remove Doors. Pre
-
drill
holes into each Rib and at similar spacings into Overdoor
Flashing. At approximately 1/3 in from each end of Door
Tracks put a 50mm nail. Rivet rest of holes.
Step 1:
Top Door Tracks:
Mark the centre of the doorway on
the Overdoor Flashing. Position Centre Door Stop on
the front face of the Overdoor Flashing and up against
the underside of roof. Pre
-
drill holes and nail in place
with 50mm nails.
Step 5:
Clean out ALL drill filings. Also make sure the
Wheels are cleaned of drill filings. Re
-
hang Doors,
then insert door stops into the pre drilled holes at
end of tracks as shown in diagram. Tighten with
two spanners
Door Track
Bolt
Washer
Washer
Nut
Aluminium
Door Stop
DOOR
GUID
DOOR
CLADDING
BOT-
PLATE
Step 6:
Bottom Door Guides:
Slide Door to corner. Hang Door Guide (A108) on bottom of the Door. Lift up approximately 3mm so
that the Door will Slide freely. Pre
-
drill hole and nail in place using a 50mm nail. Slide to centre. Ensuring Door slides freely,
pre
-
drill hole and nail Door Guide in place. Check Door is not binding in the middle then pre
-
drill holes into each Rib at similar
spacing into Door Step Flashing. Nail off using 50mm nails. Repeat with other Door.
Note:
For sheds with Raised Base Plate option the Door Step Flashing will protrude down past the Bottom Plate. Attach Door Guide
with rivets.
Summary of Contents for MK4C
Page 1: ...Quality Built In ASSEMBLY INSTRUCTIONS MK4C BASE SIZE 4210mm x 4210mm ...
Page 4: ......
Page 17: ......
Page 18: ......
