❏
Step 1. From bags PA001 and PA003, remove the (2) throttle
servo mounts, (2) servo mount spacers, (4) 3 x 8mm
self-tapping screws, and (4) 3 x 15mm self-tapping screws.
❏
Step 2. Snap together the servo mounts and the servo
mount spacers by placing the servo mount spacer on the
bottom of the servo mount and then rotating the spacer into
place.
❏
Step 3. Use the (4) 3 x 8mm self-tapping screws to attach
the throttle servo to the throttle servo mounts.
❏
Step 4. Use the (4) 3 x 15mm self-tapping screws to
attach the throttle servo and the mounts to the chassis.
Make sure that the servo spline will be towards the rear.
❏
Step 1. From bags PA001 and PA003, remove the brake
rod, the throttle rod, the brake spring, (3) 3 x 3mm set
screws, the 2mm nut, the rod connector, and (3) 2mm
collars.
❏
Step 2. From your radio system remove a large, X-shaped
servo arm. Install the rod connector in the last hole on one
arm (approximately 3/4" or 18mm). You will need to enlarge
the hole with a hobby knife or a 5/64" (2mm) drill to fit the
rod connector. Apply a small amount of thread locking
compound (not included), on the nut to hold it in place.
Secure the rod connector to the servo arm with the 2mm
nut. Do not tighten the nut completely. The rod connector
should swivel easily.
3/4"
(18mm)
SECTION 4: THROTTLE & BRAKE LINKAGES
SECTION 3: INSTALLING THE THROTTLE SERVO
7
