4
1. Install the batteries in the transmitter and
the receiver battery holders.
2. Extend the transmitter antenna.
3. Connect the steering servo, throttle servo
and receiver battery to the receiver.
4. Extend the receiver antenna.
5. Adjust the servo trims of the transmitter to
the neutral position.
6. Switch on the transmitter.
7. Switch on the receiver.
8. Operate the steering and throttle control.
Make sure the servo arms move in
proportion to the movement of the
steering wheel and throttle trigger.
9. Switch off the receiver, then the transmitter.
Before installing the radio system in the
pre-built DuraTrax Maximum ST read the
manufacturer’s instructions manual and
follow the instructions shown below.
Servo Arm
Steering
Servo
Throttle Servo
Receiver Battery Holder
4-AA Batteries
Transmitter
5
6
1
Antenna
4
8-AA Batteries
1
Receiver
3
Receiver
Switch
7
Antenna
2
8
PREPARING THE RADIO SYSTEM
ASSEMBLY OF THE PRE-BUILT VERSION (DTXC0055)
Place a check mark in the check boxes after each step is
completed.
❏
Step 1. From bags PA001 and PA003, remove (8) 3 x 8mm
self-tapping screws, and the (2) L-shaped servo mounts.
❏
Step 2. Attach the servo mounts to the steering servo
with (4) 3 x 8mm self-tapping screws. Note that the servo
spline will mount towards the rear of the truck.
❏
Step 3. Attach the steering servo assembly to the chassis
with (4) 3 x 8mm self-tapping screws in the holes provided
as shown above.
SECTION 1: STEERING SERVO ASSEMBLY
