❏
Step 1. Cut out (4) body mounts, (2) body mount brackets,
(1) bracket holder, (8) body washers from the parts tree. You
will also need (4) 3 x 15mm self-tapping screws, (4) 3 x 12mm
self-tapping screws, and (4) 3 x 6mm self-tapping screws.
Rear Body Mount
❏
Step 1. Use the 3 x 15mm self-tapping screws to attach
the body mount bracket to the bracket holder. Attach it to the
third (middle) hole on the bracket holder. Pay attention to
the direction of the body mount bracket. The holes that will
attach the body mounts must face the rear.
❏
Step 2. Use (2) 3 x 12mm self-tapping screws to attach
the bracket holder to the rear of the gearbox.
❏
Step 3. Insert the body mounts through the holes in the
body mount bracket. It should be 1-9/16” (39mm) from the
top of the body mount to the top of the body mount bracket.
Use (2) 3 x 6mm self-tapping screws to hold the body
mounts to the body mount bracket. Make sure that the holes
for the body pins align front-to-rear (see photo).
Front Body Mount
❏
Step 1. Attach the body mount bracket to the front support
with (2) 3 x 25mm self-tapping screws. Make sure that the
holes for attaching the body posts face the front.
❏
Step 2. Insert the body mount into the body mount
bracket. They should be 1-7/8" (48mm) from the top of the
body mount bracket to the top of the body mount. Attach the
body mounts with (2) 3 x 6mm self-tapping screws. Again,
make sure that the holes for the body clips are aligned front-
to-rear.
SECTION 7: INSTALLING THE BODY MOUNTS
10
