5. MEGAVOICE COMMANDS V.3.0
This expains the different commands. First is syntax, then fields are explained, then notes.
5.1 LOGIN INTO PROGRAMMING STATE 0
0 n n n n n n # OR 0 # if password is not used. Read notice.
,nnnnnn=password with 6 numbers. Default nnnnnn= <is not written here, see 3.4>.
Display : Before command "Login".
Device : Line 1 is called. Some PABX require that a function code is now entered to start
DTMF-sending. It is stated is the PABX manuals. Wait for megavoice answer.
Dial 0 nnnnnn #. Megavoice sends OK-beeps, green led is lid and the display indicated
"Enter command". The message of the line is halted. When megavoice answers the line, it
waits for 2 second before it starts its message. Dial this comand immediately the Megavoice
answers. The Spoken message wmay interface with the Dual-Tone-codes.Eg. 0 123456 #.
Note :
If mode switch is activated with * 594* 3# (as default )and the device is in PROGRAM-
state, 0 # is not used for login. Megavoice answers then and goes directly into programming
state and gives 2 beeps= OK
5.2 LOGOUT OF THE PROGRAMMING STATE 0
0 #
When used during programming, program exits the programming state and hangs up.
Display indicates "logout " followed by "login". Eg. 0 #.
Note :
If Mode Switch is activated by 594 2# or 594 3# commands AND the Mode
Switch is in Program-state, THEN the line is hung up if the switch is changed into other state.
Useful to exit the programming state.
5.3 ERASE MESSAGE 1
1 m #
m= message number 1... muodossa. If m=
clear all messages (= command 1
#).
Default is all messages empty. Guiding message 9( and all) can be erased only if sw8 is
1=down.
Megavoice : Beeps once for every 8 s erased. When ready beeps twice as OK-tone. Error
tone (9-beeps) is given when there is an error. Eg. Erase message 1 is 1 1 #.
5.4 RECORDING MESSAGE 2
2 m #
m= message number 1...9
Megavoice : Gives one beep 2 s after this comend to indicate start of recording. Recoring is
stopped with # command or with 9-beeps error tone is memory is full or message is not
empty. # beep is not recorded.
The front panel leds acts as UV level meter. The red led may occasionally flash during
recording. Recordings are stored into chip memory for 20 years. See also chapter Recoring.
Message must be erased before recording a new one. Eg. Record msg 1 is 2 1 #
Eg
5.5 PLAY MESSAGE 3
3 m #
m= Message number 1...9 . Command plays back a recorded message.
megavoice : Gives on wait-beep and play message mm , ends with wait -beep, and gives
OK-beeps.
Display indicates the number of the message. Play back can be halted with #.
Eg. Play message 1 is 3 1 #. Play message 2 is 3 2 #
V
V
V
V
V
V
V
V
V
V
V
V
VV
V V
V
V
V
V
Dial
V
2 1 #, wait for a beep, record and stop with #. Play back it with
V
3 1#. (See 5.5)
V
V
V
13
MEGAVOICE 2000 V.3.1 MANUAL V.2000-09-20
