DuraTech Industries Haybuster Balebuster 2620, Operating Instructions And Parts Reference

Page: 35 / 126

25
2 6 2 0 B A L E B U S T E R O P E R A T I N G I N S T R U C T I O N S
3.3.16 Deflector Adjustments
The deflector can be positioned for creating a windrow, spreading, bunkfeeding, or stockpiling. Lower the deflector for
a narrower windrow and raise the deflector for a wider spread.
To change the position, remove the locking pin and firmly grab the deflector latch handle and lift the release lever with
the other hand. Rotate the deflector to the desired position and release the handle. Reinstall the locking pin. Handle
tension can be adjusted by removing the deflector shield and adjusting the spring tension bolt. Reinstall the shield after
tension is adjusted. A wider deflector belt (PN 8100819) is available for bunk feeding or additional material control.
3.3.17 Jack
An adjustable jack is provided with the machine to support the hitch when the machine is disconnected from the tractor.
The jack must only be used on firm, level ground or similar base to prevent it from sinking,
When unhooking the machine remove the jack pin and rotate the jack to the upright position and reinstall the pin.
Crank the jack until the hitch is no longer supported by the drawbar of the tractor. The hitch pin can now be removed.
WARNING: Never use the jack without reinstalling the jack pin.
When hooking up the machine, install a proper hitch pin and secure it with a hairpin clip or comparable device, crank
the jack until the foot of the jack is fully raised. Remove the jack pin and rotate the jack so that the foot of the jack is to
the rear of the machine. Reinstall the jack pin.
figure 3.6
deflector adjustments -
locking pin, deflector
position indicator,
deflector latch handle
and deflector release
handle
deflector locking pin
deflector position
indicator
deflector latch handle
deflector release
handle