8
OPERATION PROCEDURE:
1.
Installs 2 pieces of 1.5V #3 batteries, then the screen will display as following “Drawing A” and have
“Bi” sound at the same time, then enter to the personal data setting and press “MODE” button for
confirmation.After that, it goes to the next step to the main menu as “DrawingB”.
Drawing A
Drawing B
2.
Get access to the set-up mode of TIME/DISTANCE/CALORIES/PULSE. When you are in each set- up
mode, for example in the time set-up mode, time value is blinking, you can use joggle wheel to adjust
the value and press “MODE” for confirmation. The set-up of DISTANCE, CALORIES & PULSE is the
same.
3.
With any signal been transmitted into the monitor, the value of TIME, DISTANCE, CALORIES start to
count up as Drawing C. When there is any function has been preset the target (TIME or DISTANCE or
CALORIES), the function will be counting down from the preset to zero while the training starts. Once
the target is achieved to zero, the monitor start to beep for 8 seconds, and the function will be counting up
from zero directly if the training is going. Press “MODE” button for confirmation and skip to next set-up.
4.
In SCAN mode shown as “Drawing C”. RPM/SPEED/TM/DIST/CAL/PULSE will skip to display in
every 6 seconds. The order is asfollows.
Drawing C
5.
Youcan also press “MODE” button to select single function display except RPM & SPEED
function. The RPM & SPEED function will switch display.
6.
RECOVERY
:
(1) When the user presses “RECOVERY” button, the RECOVERY function is active. At this timeonly
PULSE and TIME is working, other functions will not be displayed, and the Sensor Input is
not available. TIME starts to count down from ”0
:
60”, Pulse signal will be blinking according user’s
heart rate BPM. When Time counts down to “0”, it will show F1~F6 (F1 is the best, F6 is the worst).
(2) LCD display as follows: (RECOVERY start condition & endcondition).
(3)
If the count down action to
0:00
is not completed and there is no pulse signal, the count down action
has to be done and shown F6.
(4) If you press the RECOVERY button prior to count down to
0:00
, it will be end and
return to the
main menu.