9
TROUBLE SHOOTING GUIDE
1.
Verify that all the bolts and nuts are locked properly and the turning parts should be turned freely
without damaged parts.
2.
Clean the equipment with soap and slightly dampcloth only.
Please do not use any
solvent to clean the equipment.
Problem
Potential Cause
Corrections
Base is unstable.
1.
Floor is not flat or there is
small object under the front
or rear stabilizer.
2.
The rear stabilizer end caps
have not been leveled when
adjusting.
1.
Remove the object.
2.
Adjust the rear stabilizer end caps.
Handlebar is
shaking.
The Bolts are loose.
Tighten the Bolts.
Loud noise from
the moving parts.
The interval of the parts is
improper tighten.
Open the covers to adjust.
No resistance when
riding the bike.
1.
The interval of the magnetic
resistance increases.
2.
Tensioncontrolknobis
damaged.
3.
Beltslips.
4.
Thebearingsetisdamaged.
1.
Open the covers to adjust.
2.
Change the tension control knob.
3.
Open the covers to adjust.
4.
Change the bearing set.
If you still can’t solve the problems after taking the solutions above, please contact our
Customer Care @ [email protected] or 6383151885/7806811343 to resolve the issue through our
Pan- India Service Network.
