Install Valance Trim
1
. You may start the Trim Valance at either front corner.
2
. Feed the vinyl bead edge of the Trim Valance along the Valance Track of the Front Support until you reach
the other corner. Adjust Valance so that you have an equal amount of Valance remaining at each corner.
Hint:
The Valance will slide more easily if one person pulls the leading end of the Valance along the Track
while another feeds it into the Track.
3
. Feed the Valance Bead along the Valance Track on both Side Trims to the wall of the RV.
4. Trim the end of the valance so it will butt against the RV wall. You should
use a “hot knife” or heat the cut end so the material won’t fray.
Install Mounting Rail End Caps
Attach End Caps to both ends of Mounting Rail with 1/2” Thumb Screw and
Wing Nut. You will need a 3/16” drill bit to pre-drill hole.
Side View of
Slide Out Cover folded down
showing Lock Down Bracket
installation.
Off Season Storage (continued)
End Cap
Page 12
Note: the views of the Lock Down Bracket below are shown for clarity but for ease of assembly rotate
90 degrees.
Side View of
Slide Out Cover folded down.
Summary of Contents for DFSOC-10
Page 14: ...Notes Page 13...
Page 15: ...Notes Page 14...
