Page 9
Front View of Slide Out and Slide Out Cover
Header Angle
v
3. Pre-Drill the Header Angle and install the fasteners in an appropriate amount from each edge and then
every 12” as shown in the Front View illustration below.
1. Lower the Slide Out Cover down to the Header Angle and determine the location of the 1/4”-20 x 2” aluminum hex
head bolts and 1-1/2” dia. washers.
2. Use a chalk line to mark the horizontal location of the bolts.
3. Mark the vertical location of three (3) bolts per panel for attachment thru the Header Angle. Use a 1/4” drill bit and
drill your fi rst hole and install the bolt with 1-1/2” washer thru the Slide Out Cover and Header Angle.
4. Install 1” Fender Washer and 1/4”-20 Wing Nut to keep the Slide Out Cover from moving.
5. Drill for and install the remaining fasteners as per illustration(s) on next page.
Installation of the 1-1/2” x 2-1/2” Header Angle
Attachment of Slide Out Cover to Header Angle
Side View of Slide Out and Slide Out Cover
Header Angle
Slide Out Face
1. Hold the Slide Out Cover up and extend the RV Slide Out. Locate and mark where the Header Angle is to be attached
to the face of the RV Slide Out. The Header Angle should be fl ush with the top of the Slide Out and fi t between the two
(2) Valance legs of the Slide Out Cover.
2. Because there is no way to know the confi guration of every RV Slide Out it will be necessary for the installer to select
the proper fastener for the Header Angle installation to the RV Slide Out. (Use a minimun #12
fastener)
Summary of Contents for DFSOC-10
Page 14: ...Notes Page 13...
Page 15: ...Notes Page 14...
