UP200-GSM Rev.1.2 08/01/2014
Administration operations
These menu items serve for reading, writing, saving
etc. the settings.
Buttons
The intercom unit calls the phone numbers entered
here when the appropriate button is pressed. If both
phone numbers are set to any button, the unit calls the
primary phone number first.
In case of an unsuccessful call (e.g. if the called
number is not available or the call is not accepted),
calling the secondary phone number can be done by
pushing the button again (within 60 seconds). If the
Automatic
option is enabled, then the unit calls the
secondary phone number if the primary fails without
having to push the button again.
Control of outputs
The two outputs of the unit can be controlled by
multiple configured events. You can choose the
activation event according to the usage.
OUT
The voltage output, e.g. for direct control of an electric
lock.
RELAY
The relay contact output, e.g. for garage door control.
You can select the activation event and the normal
state of the output (idle state) from the drop-down
menus. Upon activation, the output state changes for
the configured time period.
General settings
Ring time
(10-120 sec)
The maximum time allowed for ringing from pushing
the call button. This function is useful to avoid
switching to voicemail.
Call time
(10-600 sec)
The maximum time allowed for a call initiated from the
intercom.
OUT active time
(1-120 sec, monostable)
The voltage output activation time.
RELAY active time
(1-120 sec, monostable)
The relay contact output activation time.
SMS forward
Forwards the SMS messages received on the unit’s
SIM card to the specified phone number, e.g. balance
information received from the GSM service provider. It
is recommended to configure this in case of using a
pre-pay type SIM card.
Gate control
When calling the intercom from the phone numbers
specified here, control of the output or outputs
assigned to the given phone number is performed.
The incoming call is not accepted, thereby this
function works with free calls. Maximum 100 user
phone numbers can be added.
Status information
Displays information about the switching state of the
peripheries and the actual status of the mobile
network.
State messages
The messages shown in this window give information
about the internal operation of the unit. This helps in
identifying
an
internal
process,
an
incorrect
configuration or other malfunction.
The question marks placed next to the settings in the
Intercom configurator
give assistance to the
parameter settings of the given section.
Read
Click to read and displays the
settings from the unit.
Write
Click to write the settings to the
unit’s memory.
Save
Click to save the settings to file.
Open
Click to open saved settings
from file.
Firmware
Click to update the intercom’s
firmware.
English/Magyar
Click to change the
Intercom
configurator
’s interface
language.
Progress bar
