UP200-GSM Rev.1.2 08/01/2014
SETTING WITH SMS COMMANDS
Configuration of the unit is possible by sending the appropriate commands in SMS to the module’s phone number. It
is possible to send more commands (settings) in the same SMS, but the length of the message must not exceed 140
characters! Each message must begin with the password using the
PWD=
password
#
command and each command
must end with
#
character, else the module does not apply the modifications. The following table contains the
configuring and query commands:
Configuration commands
PWD=
1234
#
Password for programming, default setting:1234
PWC=
new password
#
Changing the password. The password is a 4-digit number.
RESET#
Resetting the settings and the password to default.
UPTEL1=
phone number
#
Primary phone number for upper pushbutton.
UPTEL2=
phone number
#
Secondary phone number for upper pushbutton.
UPAUTO=ON#
vagy
OFF#
In case the call to UPTEL1 fails, UPTEL2 phone number will be called
without having to push the button again, if the parameter is ON.
LOWTEL1=
phone number
#
Primary phone number for lower pushbutton.
LOWTEL2=
phone number
#
Secondary phone number for lower pushbutton.
LOWAUTO=ON#
or
OFF#
In case the call to LOWTEL1 fails, LOWTEL2 phone number will be called
without having to push the button again, if the parameter is ON.
OUT=
activation event
#
Voltage output control:
OFF
: disable,
BUTTON
: when button is pressed
INPUT
: when input is activated,
PHONE
: during call, pressing any of the
ph
one’s keys,
IN+PHONE
: INPUT and PHONE enabled
RELAY=
activation event
#
Relay control:
OFF
: disable,
BUTTON
: when button is pressed
INPUT
: when input is activated
RINGTIME=
duration
#
Ringing time of the telephone to restrict the reach of voice mail. (10-120sec)
CALLTIME=
duration
#
Maximum duration of the conversation. (10-600 sec)
RTIME=
duration
*NO#
or
NC
Duration and idle mode of the relay output activation. (1-120 sec)
OUTTIME=
duration
*NO#
or
NC
Duration and idle mode of the voltage output activation. (1-120 sec)
RTEL=
phone number
*REL*OUT#
Setting the phone numbers for relay or voltage output activation. For output
activation the suffix after the phone number is necessary.
*REL
: switch the realy,
*OUT
: switch the voltage out,
*REL*OUT
switch both. Up to 100 users.
RTELDEL=
phone number
#
Delete the selected phone number.
STATUS?#
Query of the settings except RTEL list.
RTEL?#
Query of the RTEL list.
INFOSMS=
phone number
#
Forwards the incoming SMS messages.
This scenario shows the configurations for the following requirements: phone number 2 only for upper pushbutton,
auto switch to the secondary phone, VOUT control (for electric lock) by phone and input contact, duration is 10sec,
both phone numbers are able to control the gate control’s relay by a free call, relay activation time is 5sec.
Other call parameters: Ringingtime=25sec; maximum duration of the conversation=120sec; forwarding prepaid card
information to primary phone number
SMS message:
PWD=
1234
#UPTEL1=
0036309999999
#UPTEL1=
0036201111111
#UPAUTO=ON#OUT=IN+PHONE#
OUTTIME=
10*NO
#RTEL=
0036309999999
*REL#RTEL=
0036201111111
*REL#RTIME=
5*NO
#
RINGTIME=
25
#CALLTIME=
120
#INFOSMS=
0036201111111
#
