DUPLOMATIC
E.M.6427 RELEASE 7.1 05-03
6427071-230-en 3
1. GENERAL INFORMATION
The Duplomatic control unit is a compact system that controls all functions regarding positioning
and driving of the
SM* turrets Duplomatic
.
The interfacing to the lathe is powerful and simplified
for an easy installation
.
Serial line RS232 is set for diagnostic and remote control by PC.
CODE OF THE CONTROL UNIT
It is possible to see all the data concerning the control unit looking at this stamp, applied on its
rack.
Correspondence:
Model:
DDC1-12-K20/ 22
Software version:
SFW062I003
for SM-20
IMPORTANT NOTE FOR SAFETY
Do not manipulate the inside of the unit
Only personnel authorized by Duplomatic may manipulate the
inside of this unit.
Do not manipulate the connectors with the unit connected to AC power.
Before manipulating the connectors (inputs/outputs, feedback, etc.)
make sure that the unit is not connected to AC power.
The control unit, even after the power off of the supply, stores internally electric
power until the power capacitors are charged.
Be careful when operate on it.
EMC COMPLIANCE
The turret has been tested under the condition reported as follows and obtained the compliance
for: CEI EN 61800-3 and CEI EN 61800-4.
