Duplo DB-250, Service Manual

Page: 16 / 65

12
6-7 PADDING MODE:
“PAD” is one of the DB-250 operations that apply to special binding
applications such as binding without cover sheet.
1.
Press “FUNCTION” button to switch to
“PAD” operation. The “PAD” LED will be lit
and display flashing "LOAD PAD" as shown.
Note:
The “NOTCH” LED is normally OFF. But
you can press “NOTCH” button to actuate it,
if desired.
2. (1) Press the “OPEN” button. Be sure to
follow the label instructions on the clamp
To load the pad block to the RIGHT of
the red line, then slide the pad block to
the far LEFT of the clamps and you will
see the flashing "PUSH CLOSE" display.
Step 1:
Load book to the
RIGHT of the red line.
Step 2:
Slide the book to
The far LEFT.
(2) Then press the “CLOSE” button to clamp
down the pad block and you will see the
flashing "PUSH START" display.
Note:
In case you need to adjust the pad block after
you have closed the clamps, you can press the
"OPEN" button twice to release it. The LED
display will show "PUSH CLOSE". After you
have adjusted the pad block, you have to press
"CLOSE" button until the clamps close. Then
you will see the flashing "PUSH START"
display again.
3. (1) Press the “START” button. The LED
display of control panel will show a “
ß
”
sign and the clamp station will move over
the notching station and return to clamp
station.