JET VAC ALPHA
7. OPERATING INSTRUCTIONS
(a)
After opening the packaging box eventually fix the machine on the trolley.
(b)
Plug the power cord (19) into the electric socket (10) and verify that the vacuum power switch (18) is in ON position.
(c)
Lift the tank cap (11) and add water to the water tank,
we recommend to exclusively fill with water only, any
other
liquid except Hydroscale (Duplex recommended scale inhibitor) may damage the generator
permanently
.
(d)
Insert the plug (1) into an electrical outlet, making sure that the voltage and the amperage correspond with those printed on the plate of
the machine (on the inferior part).
WARNING
WHEN THE WATER TANK IS EMPTY THE LOW WATER INDICATOR (2) SWITCHES ON AND THE STEAM OUTPUT WILL BE
DISABLED UNTIL WATER IS ADDED TO THE WATER TANK (9).
PLEASE NOTE: THIS OPERATION CAN BE CARRIED OUT WITHOUT SWITCHING OFF THE MACHINE.
USE OF THE ACCESSORIES
Insert the vacuum hose (30) into vacuum hose outlet (13) and the steam plug (32) into the steam outlet (6) found on the front of the machine.
Push until the latches (14 and 31) lock into place.
Activate the power switch (4) and the boiler switch (5) for the production of steam and wait approximately 5 minutes until the green "ready
steam" indicator (3) on the command switch lights up indicating that the boiler has reached the operating pressure. The switches (35,36 and
37) located on the handle should be in OFF position.
When the indicator (3) lights up, position the switches (36 and 37) on the handgrip to regulate the steam flow as follows: switch (36) minimum
flow, switch (37) medium flow, switches (36) and (37) maximum flow. Use the security trigger (34) to activate the steam flow.
The vacuum switch (38) activates the vacuum and can be used simultaneously with steam, the power can be regulated by pressing the +
and – symbols on the electronic regulation (12) on the vacuum head.
The switch (35) enables you to inject overheated water with the steam by activating it for a few seconds at a time to avoid exceeding the
injected liquid to the steam.
To clean with the combination of steam, injection of overheated water and vacuum suction choose the accessory best suited for the job:
Warning!!
By pushing the switch (35) overheated water under pressure with a high temperature, according to the model,
of up to 180 °C will come out of the lance. Please be careful not to action this switch without alert and do not
align the jet towards persons or animals.
To clean with the combination of steam, injection of overheated water and vacuum suction choose the accessory best suited for the job:
The multi-purpose floor tool (51): with appropriate inserts (53,54,66,67). Inserts are locked into place by sliding the latches (52) to the OPEN
position and hold the insert in place applying a little pressure while sliding the latches in
12
DUPLEX
Summary of Contents for JET VAC ALPHA
