Dunlop DTSL3 MK2, Instruction Manual

Page: 15 / 27

DTSL3/FR MKII USER’S MANUAL
15
Chapter Chapter Chapter Chapter 5 5 5 5 ADJUSTMENT ADJUSTMENT ADJUSTMENT ADJUSTMENT
Add
Add Add
Add oil
oil oil
oil and
and and
and check
check check
check the
the the
the order
order order
order of
of of
of phase
phase phase
phase .
After installing lift as Picture 4 required and connecting hydraulic circuit and electric circuit, operate it as following:
-open the hydraulic oil tank, add 18L of hydraulic oil into the oil tank, the hydraulic oil is provided by the user.
Make sure the clean of hydraulic oil, prevent any impurity into the oil line, lead the digest of the oil line and no working of the
solenoid valve.
-Turn on " MAIN MAIN MAIN MAIN SWITCH SWITCH SWITCH SWITCH " to turn on power, clicking the ‘UP’ button, check whether the motor turns clockwise (looking
downward), if not turn off "MAIN SWITCH", then to change the phase of the motor.
When When When When turn turn turn turn on on on on power, power, power, power, tttthere here here here will will will will be be be be high high high high voltage voltage voltage voltage exist exist exist exist in in in in the the the the control control control control box, box, box, box, only only only only authori authori authori authorissssed ed ed ed person person person person can can can can operate operate operate operate it. it. it. it.
Oil Oil Oil Oil make-up make-up make-up make-up adjustment adjustment adjustment adjustment
1 Press ‘ UP UP UP UP ’ button, and then motor starts to lift two platforms to go up to the apex.
2 Open the control box of door ,and press “
UP
UP UP
UP
” button and “SB4" as picture 21 for some minutes
3 Press ‘ DOWN DOWN DOWN DOWN ’ button to let the two platforms go down until the platforms stop at the lower limit switch action position, and then
press " SECOND
SECOND SECOND
SECOND DOWN
DOWN DOWN
DOWN " button together , and the platforms will go down to the lowest position.
4The oil make-up adjustment process is over.
GROUND GROUND GROUND GROUND BOLTS BOLTS BOLTS BOLTS INSTALLATION: INSTALLATION: INSTALLATION: INSTALLATION:
The ground bolts installation must start after the expiry date on the maintenance of concert, otherwise, it will affect the quality of
solidity.
-Adjust the parallel of the platform and the distance of two platforms as Picture 4 requires.
-Fix the anchor bolts with a percussion electric drill (percussion drill bit is of 16), drill to 120 mm hole and clean the hole.
(Picture 22)
-Use light hammer to install the ground Holts into the hole (need not install the
Central expanded nail of ground bolts, install it after level adjustment.)
Picture 22
Picture 20 adjust level button (SB4)