DTSL3/FR MKII USER’S MANUAL
14
Chapter
Chapter
Chapter
Chapter 4
4
4
4 INSTALLATION
INSTALLATION
INSTALLATION
INSTALLATION
ELECTRIC
ELECTRIC
ELECTRIC
ELECTRIC CIRCUIT
CIRCUIT
CIRCUIT
CIRCUIT CONNECTION:
CONNECTION:
CONNECTION:
CONNECTION:
Follow the stated line- pathway and line-number of the ‘electrical diagram’ to connect electric circuit.
Only skilled person is allowed to perform the operations.
-Open the control box front cover.
-
C
C
C
Connection
onnection
onnection
onnection of
of
of
of power
power
power
power supply:
supply:
supply:
supply:
the 400V three-phase and five-line connection wires (3×2.5 mm
2
+
2×1.5 mm
2
cable wire) for
power supply are connected to control box L1, L2, L3, N and entering-wire terminal. The PE ground wire is connected under the bolt
marked ground firstly (Picture 15) and then connected under the bolt marked ground of two platforms.
-If the lift is operated at 230V three-phase, change the connection on the transformer and motor. (Picture 15)
----C
C
C
Connection
onnection
onnection
onnection of
of
of
of up
up
up
up limit
limit
limit
limit switch
switch
switch
switch
: up limit switch is labeled 102# and 100#, to connect them to the same no. in the control box.
----C
C
C
Connection
onnection
onnection
onnection of
of
of
of lower
lower
lower
lower limit
limit
limit
limit switch
switch
switch
switch
: lower limit switch is labeled 105# , 107# and 109#, to connect them to the same no. inside the
control box.
Oil
Oil
Oil
Oil PIPE
PIPE
PIPE
PIPE CONNECTION:
CONNECTION:
CONNECTION:
CONNECTION:
Follow “oil pipe diagram “to connect the oil pipes.
Only skilled and authorised person is allowed to perform the operations. And pay particularly attention to the protection of oil
pipe fitting. Refer to “oil pipe diagram:
-When connecting oil pipes, pay attention to the protection of oil pipe tie-in to prevent impurities from entering hydraulic circuit.
-When connect the oil pipes, be careful not to mistake each oil pipe number.
-During the standard installation, control box is in the nearside of vehicle-entering direction. If placed on the right should adjust
relevant oil pipe.
Picture 20
Picture 17 up limit switch
Picture 18 lower limit switch
Picture 19 position to fix the limit switch
Picture 14
Picture 15
Picture 16