FAX:
(650) 965•0764
TOLL-FREE [US/CA]:
(800) 446•8811
TELEPHONE:
(650) 969•8811
48501 Milmont Drive • Fremont, CA 94538
Page 14
9. Locate the J2 and J3 4-pin header. As shown in
, both headers are the
electrical components next to the heat sink.
(Previous models had the 4-pin headers labeled as J2 NEG and J2 POS)
10. Remove the header connector
11. Re-install header connector onto proper 4-pin header
Positive polarity:
J3 POS
(
J2 POS
on previous models)
Negative polarity:
J2 NEG
12. Re-install the HV diode in the proper direction according to the diagram printed on
the board directly below the HV diode (see
).
Failure to install HV diode and header connector to the same
polarity will result in damage to the high voltage transformer.
CAUTION
Figure 5.
4-pin header and HV diode diagram
