Duke X-STREAM WASH, Installation And Operation Manual

Page: 17 / 36

17
Installation and Operation of X-STREAM WASH
E-30 K5000 Control Panel
K5000 Control Panel
Timer Operation
The change water timer ( t) will retain its current
count when the washer is stopped or when power is
disconnected from the controller.
The soap delay timer ( t2) allows for a delay before soap
is dispensed into the wash tank. This allows the soap
to be added to a wash tank when it is full of water and
the circulation pumps are running.
The soap dispensing timer ( t3 ) determines the time for
soap dispensing. A time of 0.00 will bypass the soap
dispensing process.
Display Software Version
To display the software version, enter the configuration
mode (See instructions listed in the Configuration Mode
–
CnF section listed above). When CnF
displayed,
press the
DOWN
button. The software version number
will be displayed and should look something like
d.17.
Press the
DOWN
arrow button again to return back to
the
CnF display.
Exit the supervisor mode when done. NOTE: See
Supervisor Mode section on how to exit.
Display Lamp Test
A lamp test can be started by pressing the
DOWN
and
TEMP
buttons simultaneously. During the lamp test, the
controller functions normally, but all display segments
and status lights flash. Pressing the
TEMP
button again
will return back to the normal operation display.