Installation and Operation of IRHU
4
IMPORTANT SAFETY INSTRUCTIONS
In addition to the warnings and cautions in this
manual, use the following guidelines for safe operation
of the unit.
• Read all instructions before using equipment.
• For your safety, the equipment is furnished with a properly
grounded cord connector. Do not attempt to defeat the
grounded connector.
• Install or locate the equipment only for its intended use as
described in this manual. Do not use corrosive chemicals in
this equipment.
• Do not operate this equipment if it has a damaged cord or
plug, if it is not working properly, or if it has been damaged or
dropped.
• This equipment should be serviced by qualified personnel
only. Contact the nearest Duke authorized service facility for
adjustment or repair.
• Do not block or cover any openings on the unit.
• Do not immerse cord or plug in water.
• Keep cord away from heated surfaces.
• Do not allow cord to hang over edge of table or counter.
• Inspect glass daily for chips, cracks, or breaking. Discard all
food and notify manager if any chips, cracks, or broken glass
are found. Do not use equipment. All glass must be in good
condition before using equipment to hold food.
The following warnings and cautions appear throughout
this manual and should be carefully observed.
• Turn the unit off, disconnect the power source and allow unit
to cool down before performing any service or maintenance on
the unit.
• The procedures in this manual may include the use of chemical
products. You must read the Material Safety Data Sheets
before using any of these products.
• The unit should be grounded according to local electrical codes
to prevent the possibility of electrical shock. It requires a
grounded receptacle with separate electrical lines, protected by
fuses or circuit breaker of the proper rating.
• Disposal of the unit must be in accordance with local
environmental codes and/or any other applicable codes.
• SAVE THESE INSTRUCTIONS
:
GENERAL WARNING -
Indicates information important
to the proper operation of the
equipment. Failure to observe
may result in damage to
the equipment and/or severe
bodily injury or death.
:
ELECTRICAL WARNING -
Indicates information relating
to possible shock hazard.
Failure to observe may result
in damage to the equipment
and/or severe bodily injury or
death.
:
HOT SURFACE WARNING -
Indicates information important
to the handling of equipment
and parts. Failure to observe
caution could result in
personal injury
CAUTION:
GENERAL CAUTION -
Indicates information important
to the proper operation of the
equipment. Failure to observe
may result in damage to the
equipment.