DUERR-NDT CR 43 NDT, Installation And Operating Instructions Manual

Page: 20 / 36

20
9000-608-21/30 2013/10/21
18
5
3
4
2
1
This appliance is not equipped with its
own main power switch Therefore, the
appliance must be set up in such a way
that the socket outlet is easily acces-
sible in case of a possible fault and that
this is situated within the maximum
cable length of 3 m / 11811 inch
13. Initial use and start-up
13.1 Remove the transport aids
• When the appliance has been moved to its
intended location, remove the transport aids
by tilting the appliance slightly
The transport aids should fall out on
their own when the appliance is tilted If
this is not the case, pull briefly down-
wards on the cord
13.2 Setting up the appliance
The front foot (14) of the appliance is adjustable
The adjustment range is ± 3 mm / 012 inch
• Set up the appliance at its intended location
• Carefully tilt the appliance slightly to the rear
Adjust the foot, if necessary, until the appli-
ance is standing firmly on all four feet
13.3 Installation and configuration
Perform the installation and configura-
tion according to the provided operating
instructions "Installation and Configura-
tion CR 43" Order No 9000-608-61/
Connections and displays
1
Mains connection:
For connection of the appliance to the mains
power supply
2 Reset button:
By pressing and holding the Reset button for
15 - 20 seconds while switching on, all net-
work settings for the appliance are set back to
factory settings
3 Status LEDs:
Display of the device status during the service
4 AUX port:
Programming and test interface For service
purposes only
5
Network port:
For connection of the appliance to the net-
work
3
4
5
14
EN