Ducson DG121-A, Owner'S Manual & Operating Instructions

Page: 19 / 28

www.ducsonpower.com
P O W E R E X P E R T S
4
• Digital Hour Meter - Shows Generator Running Time
per time & Total Running time.
• Air Filter - Protects engine by filtering dust and
debris out of intake air.
• Circuit Breaker - Receptacle is protected against
electrical overload with circuit breaker.
• Petrol Tank - Capacity of 45L.
•
Grounding Fastener
- If required, please consult a
qualified electrician, electrical inspector, or the local
agency having jurisdiction.
• Oil Fill Cap/Dipstick - Check and fill engine with oil
here.
• Remote Choke - Used when starting a cold engine.
•S
tart Switch
- Turn to "Start" position to start unit and
"On" position for running, switch to "Off' to switch off
generator.
• Run Lamp - Lightening when it is running.
•
Oil Alert
- Lightening when the engine is shut down
without oil or low oil.
ASSEMBLY
Your generator requires some assembly and is ready
for use after it has been properly serviced with the
recommended oil and petrol.
Remove Generator From Plywooden Case
1. Set plywooden case on a rigid flat surface.
2. Carefully cut the packing straps of plywooden case.
3. Remove the whole plywooden case upward with two
people by holding its side face at the same time.
4. Remove all fixed Bolt which were attached to the
base pallet.
5. Remove generator from the pallet.
BEFORE STARTING THE ENGINE
Add Engine Oil
•Place generator on a level surface.
CAUTION
Any attempt to crank or start the engine before it has
been properly filled with the recommended oil will result
in equipment failure.
•Please fill the engine with 1.3L qualified engine oil.
•Damage to equipment resulting from failure to
follow this instruction will void warranty.
NOTE: Check oil often during engine break-in.
NOTE: The generator assembly rotates on a
prelubricated and sealed ball bearing that requires
no additional lubrication for the life of the bearing.
Add Petrol
NOTE: This engine is certified to operate on petrol
only. It will not operate on paraffin, diesel or other
fuels.
WARNING
Petrol and its vapors are extremely flammable
and explosive.
Fire or explosion can cause severe burns or
death.
WHEN ADDING PETROL
•Turn generator OFF and let it cool at least 2 minutes
before removing petrol cap. Loosen cap slowly to
relieve pressure in tank.
•Fill petrol tank outdoors.
•DO NOT overfill tank. Allow space for petrol
expansion.
•Keep petrol away from sparks , open flames, pilot
lights, heat, and other ignition sources.
•DO NOT light a cigarette or smoke.
1. Use clean, fresh, regular UNLEADED petrol with a
minimum of 85 octane. DO NOT use petrol which
contains Methanol. DO NOT mix oil with petrol.
2. Clean area around petrol fill cap, remove cap.
3. Add regular unleaded petrol to petrol tank. Be
careful not to overfill. Allow about 4cm (1.5") of
tank space for petrol expansion (Figure I).
4. Install petrol cap and wipe up any spilled petrol.
Figure 1 - Petrol Expansion Space