24
E
Lap time display
To activate this function, go into the menu and set the “LAP”
function to “On” by keeping button (1, fig. 8) in position B
“
▼
“ for 3 seconds.
START and STOP the timer by pressing the high beam
FLASH button (12, fig. 5) on the left-hand switch.
When the LAP function is active, each time you press the
FLASH button, the display will show the lap time for
10 seconds, before reverting to normal mode.
You can save a maximum of 30 laps in the memory.
If the memory is full, each time you press the FLASH button,
the display will not save any more lap times and will display
the flashing message “FULL” for 3 seconds until the
memory is reset.
fig. 18
Summary of Contents for SperBike 1098
