27
DUCATI
R A D I O K E Y P A D
ROLLING CODE DUCATI SW6500/TASTY
Radio keypad SW6500/TASTY 6500
powered by 2 lithium batteries CR2450 3V.
The keyboard is used to operate the radio
frequency automation. The transmission of the
radio signal is protected by a customized 4-digit
code.
Fix the keypad at a maximum distance of 10
m from the automation control units, 1 radio
transmission channel. Prepared for outdoor use.
The radio signal must be memorized in the
motorization electronic board with the same
procedure indicated for the remote controls (see
previous page).
WARNING
: Once a personal code has been entered, it is advisable to write it down in order to memorize it since in case of loss it will be impossible to reset the keyboard
without returning it to the manufacturer.
WARNING
: with an incorrect activation code 3 times the keypad enters security mode and will be unusable for 10 minutes. Wait 10 minutes and enter the correct code.
WARNING
: write the code digit by digit slowly.
The keypad is supplied with a standard activation code = 1111. The standard code must be replaced by a personalized secret code.
1)
CHANGE THE STANDARD CODE WITH A PERSONAL SECRET CODE
Enter on the keypad the standard code 1111 + key 3 + the new 4-digit personal secret code + the OK key (right side of the key with the arrow / OK). The keypad beeps to
confirm the operation. The standard code 1111 is automatically deleted.
2)
SAVE THE KEYBOARD TRANSMISSION CHANNEL ON THE ELECTRONIC MOTOR BOARD
- On the electronic board, press the P1 button to command a complete maneuver cycle (or P2 on the CTH43 board and CTH46 board to command a partial pedestrian
opening cycle). The red LED light will turn on. Release the P1 key; On your keyboard, type your custom code + OK button.
- The red led on the electronic board flashes briefly to confirm the memorization of the code. Procedure completed.
3)
REPLACE A CUSTOM CODE WITH A NEW CODE
On the keypad, enter your custom code + the 4 key + the new 4-digit personal secret code + the OK button. The keypad beeps to confirm the operation.
4)
ADD A CUSTOM CODE (WITHOUT DELETING THE PREVIOUS)
On the keypad, enter your custom code + 3 key + new 4-digit personal secret code + OK button. The keypad beeps to confirm the operation.
5)
CLEAR CODES (this operation clears all custom codes)
:
On your keyboard, type your custom code + the 6 key + the OK button. The keyboard LED is flashing, touch the OK button again while the LED is flashing.
WARNING
: After this operation the keypad will resume the standard code = 1111, but it will not be possible to command the gate before entering a new customized code
following the steps in point 1.
WARNING:
To delete a radio keypad from the memory of the electronic board, it is necessary to delete all its memory with the total loss of all previously memorized remote
controls. On the electronic board, press the P1 key and keep the key pressed for about 30 seconds.
- The red LED will light up, once the memory has been deleted the red LED will flash to confirm that the operation has been carried out correctly.
- Release the P1 key. Procedure completed.
