11
DUCATI
DRAWING FOR QUICK INSTALLATION
14
14
Electronic board CTH46 (12V)
Connections:
1
antenna cable.
2
antenna ground.
3
COM common.
3/4
START contact for wired command of the complete opening cycle (NO contact, normally
open).
4/5
START PED contact for wired pedestrian opening cycle command (NO contact, normally
open) the gate will open only 1 m to allow pedestrian passage).
6/7
STOP contact to connect an emergency stop button (NC contact, normally closed con-
tact). If there is no connection, keep the contact with the jumper on the board closed. if the
contact is open, the operator will stop working until the contact is closed
.
7
COM common (for photocells and for emergency stop)
.
7/8
Safety photocell NC contact 7 = common, 8 = "FTC" (NC contact, normally closed con-
tact). If there is no connection, keep the contact with the jumpers on the board closed. If the
contact has opened the operator during opening, it will close again.
And with the gate open, the gate will no longer close until the contact is closed.
9
+
12V positive power supply set Photocells.
10
Negative photocell kit power supply - 12V.
11
+ 12V positive solar panel.
12
-
12V negative solar panel.
13/14
flashing light 12V max 10W (no polarity to be respected).
Connectors (+/-)
for direct connection to 12V min 7A battery / integrated battery rechar-
ging system).
WARNING:
photocell jumper between terminals 7 and 8. Remove only the jumper when
connecting a set of photocells.
WARNING:
emergency stop jumper between terminal block no. 6 and 7.
Remove the jumper only when connecting an emergency stop switch
.
WARNING:
Be careful when connecting the battery and solar panel to respect the polarity
of the connections:
+ = + positive = red cable
- = - negative = black cable / blue
230V mains power input (non-solar configuration)
using the toroidal transformer: power the board with the output cables 0 (black) 12V (yellow)
with no polarity to be respected.
Buttons
:
P1 = button to memorize remote controls to complete the maneuver cycle.
P2 = remote control memorization button for pedestrian maneuvering cycle.
Potentiometers:
TIME =
to choose between step-by-step operation mode (= 0) and timed automatic reclo-
sing.
POWER =
to adjust the engine power (increase or decrease the sensitivity in case of impact
on an obstacle).
CTH46
CTH46
0
max 100
sec.
Power
Time
START
contact to initiate the
pedestrian maneuver
(NA)
START
contact for start-up (NO)
1
2
N.C.
Photovoltaic solar
panel
12V min.10W
Flashing
12V max 10W
FTC photocell contact
(
NC)
+
12V PPositive output power
-
12V Negative output power
COM
common
ST
OP
emergency stop contact
(NC)
ST
OP
( NC)
COM (
common
)
-
12V negative panel cable
+
12V positive panel cablesolar
-
Fuses
0,8AT
5 x 20 mm
TIME POWER
DUCATI
CTH46
QUICK INSTALLATION: Electronic board diagram (see page 20)
