Light control
Low / High beam
By means of button (A) it is possible to switch from
low beam to high beam and vice versa: position (B)
for high beam, position (C) for low beam. To flash,
press the button in position (D).
If engine is not started after turning the key to on, it
is nevertheless possible to switch on the lights or
flash.
If within 60 seconds from the manual switching on of
the low or high beam the engine is not started, the
lights are turned off.
To preserve the motorcycle battery, the headlight is
automatically switched off when starting the engine
and it is then switched on again when the engine has
started.
DRL in "Auto" mode only for version with DRL
lights
If the DRL was set to "Auto" via the "DRL" function
within Setting menu (page 157), the instrument
panel automatically manages the DRL and the low
beam according to detected ambient light:
●
if the instrument panel detects good light
conditions (day) the DRL is turned on and the
low beam is turned off;
●
if the instrument panel detects poor light
conditions (night) the DRL is turned off and the
low beam is turned on.
When the DRL is set to Auto mode, the
corresponding warning light (13, Fig 71) will turn on.
If the DRL was set to "Auto" mode, press button
(E, Fig 207) to disable that mode and set manual
light management. Press again button (E, Fig 207) to
E
A
D
B
C
Fig 207
204
Summary of Contents for MULTISTRADA Series
