R&G Racing
Unit 1, Shelley’s Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Email:
- 1 -
FITTING INSTRUCTIONS FOR PKS0059 KICKSTAND SHOE
GENATA XRZ 125 2013-
Please note that the way the kit is packed does not necessarily represent the way of
mounting to the bike.
T
HE PARTS SHOWN MAY BE REPRESENTATIVE ONLY
(
FOR CLARITY OF INSTRUCTIONS ONLY
)
Please note that in cases where kits are packed with rubber washers holding the components onto the
bolt –
the rubber washers should be thrown away
!
BASE PLATE CLAMP PLATE AND BOLTS
TOOLS REQUIRED
•
3mm A/F Allen key.
FITTING INSTRUCTIONS
•
Place the clamp plate (pictured above right) over the side stand base and position up the side
stand shaft with the counter-sinks upper-most.
•
Take the aluminium machined base plate (picture above left) and fit to the base of the side
stand from underneath so it is aligned with the clamp plate.
•
Apply a small amount (one drop) of Loctite Blue 242 to the end of the threaded area of each
screw.
•
Use the three counter-sunk bolts to secure in position, ensuring the inside edge of the clamp
plate clamps down on the top of the side stand base
