25
ITALIANO
ENGLISH
Radio-command codes self-learning :
Press the
P1
push-button once to insert a “Opening Start” code; press
the
P1
push-button twice to insert a “Closing Start” code. Each time the push-button is pressed, the led DL1
flashes in acknowledgement. Subsequent pressures of the
P1
push-button must be spaced by 1 sec. minimum
periods. When the led is lit with a fixed light transmit the code to be learn by means of the radio-command.
Erasing all stored codes
: Press push-button P1 until the led DL1 goes off (about 10 seconds).
Setting the work time :
Press the
Closing start
push-button or the corresponding push-button on the
radio-command until the roller shutter is completely closed. Press push-button
P1
for about 3 seconds (the led
will light with a fixed light) until the roller shutter starts to open. When it is completely open press push-button
P1
again. The roller shutter will stop and the led will go off.
G) PROGRAMMING THE BOARD
jumper inserted between 1
and 2 terminals
Cyclical mode
1 2 3
Manual logic
jumper inserted between 3
and 2 terminals
JP1
1 2 3
Step-by-step logic
jumper not inserted
JP1
1 2 3
JP1