21
ENGLISH
10) O
PERATION
MODES
Introduction
The electronic unit contains a micro-processor to control the roller shutter’s operation modes.
These are the main operation modes :
“Step-by-step” mode (JP1 jumper = not inserted)
When the roller shutter is closed, the opening start command determines an opening cycle.
At the end of the work time, the roller shutter stops. The operating cycle is completed and the
system waits for a closing start command. If a opening start or closing start command is
supplied when the end of travel has not been reached yet the roller shutter stops.
Manual (JP1 jumper = inserted between 3 and 2 )
The roller shutter move until the (opening or closure) push-button is pressed.
Note : The opening start and closing start commands can be supplied by the two
push-buttons of radio-command.
“Cyclical” mode (JP1 jumper = inserted between 1 and 2 )
In cyclical mode the difference between the opening start and closing start commands is
cancelled and both commands have the same function. The operation is controlled by a single
start command. In cyclical mode the “step-by-step” operation logic remains unchanged.
Notice: The operation logic setting (jumper) and the work time programming must be
carried out only if the cycle is concluded or before it starts (with closed roller shutter).