23
ENGLISH
Terminal 3 -
230 Vac motor M1 power supply common
Terminal 4 -
230 Vac motor M1 power supply phase (opening)
Terminal 5 -
230 Vac motor M1 power supply phase (closure)
Note
: connect the capacitor of the motor M1 between terminals 4 and 5
T
ERMINAL
BOARD
J2
Terminal 1 –
Opening start push-button’s normally open electric contact
Terminal 2 –
Closing start push-button’s normally open electric contact
Terminal 3 –
Common terminal for all electric contacts of commands
Terminal 4 –
Aerial input (signal)
Terminal 5 –
Aerial input (shield)
C
ONNECTION
OF
THE
DEVICES
230 Vac mains power supply cable and ground –
Terminals 1 and 2 on J1
Warning: The cable’s ground pole must be connected to a good ground reference in
the roller shutter’s nearby area.
Motor 1 –
Terminals 3, 4 and 5 on J1
Aerial –
Terminals 4 and 5 on J2
NO Opening start push-button –
Terminals 1 and 3 on J2
NO Closing start push-button –
Terminals 2 and 3 on J2
Important: Before starting the roller shutter check all connections to the electronic
card. Check also the electric contacts’ switching.
