Ducasa Colorado DGi+, Manual

Page: 8 / 20

8
Wednesday
11:00
21
.5°C
Wed. 11:00
Set point:
COMFORT
Wed. 11:00h
21
.5°C
Set point:
21
.5°C
Wed. 11:00
Set point:
COMFORT
If you don’t have the access to the
App or are unable to pair using the method
above , press the Link button on the Gateway
3
for 3 seconds.
Once the orange LED starts to flash, press the
CONFIG button on the Colorado DGi+ and press
the +/- button until the RF icon
flashes. Then press OK
‘Link’ together with an antenna
icon will appear in the top right
of the screen.
Your Colorado DGi+ is now
connected to the Gateway.
Please Note : Once the
Gateway’s link button is pressed you have one
minute to add a heater. When the heater has
been added, you have one minute to add a further
heater without pressing button
3
GEOLOCATION
This mode allows your
system to reduce the set temperature by a number
of degrees that is configured for each device from
the App when you are away from home. The
default is 2 degrees.
Geolocation is activated from the
App within the Homes setting. If activated,
all connected devices in
the house will use this feature and AWAY will be
shown on the Colorado DGi+ display.
If any button is pressed
on any connected
device, all
devices in the
house will exit Geolocation
mode for 2 hours, unless
it’s turned back on again.
USING WITHOUT SMARTCOMMAND TEVOLVE APP
USING IN OPERATING MODES
To assist with the operation of the Colorado
DGi+, the TFT screen is backlit and will stay
illuminated for approximately 10 seconds after the
last button is pressed. (To change the backlight
duration, see the section on DISPLAY)
When the towel rail is operational and the room
temperature is lower than the set temperature the
heating symbol will be shown indicating that
the towel rail is producing heat.
The following screens show MANUAL , AUTO
and OFF modes.
To scroll between MANUAL and AUTO press
Mode/OK button.
To enter and exit OFF mode press the ON/OFF
button. When OFF mode is exited, it returns to the
mode used prior to entering OFF mode.
When the towel rail is in MANUAL mode the
temperature can be adjusted by pressing the +/-
button. The towel rail will regulate the room to the
chosen set temperature.
When the towel rail is in AUTO mode the
temperature can be adjusted by pressing the +/-
buttons. This change will remain active until either
the next programme change or until midnight when
the temperature will revert to the preset value.
When the temperature has been adjusted in
AUTO mode a hand will show beside the auto to
symbol to show the amended set-point.
To return to AUTO mode press the Mode/OK
button.
NOTE: To rapidly change the temperature set-
point in any mode press and hold the +/- button.
orange
green