Ducasa Colorado DGi+, Manual

Page: 14 / 20

14
Runback Config
Setback
Max. Temp.
Runback
Max Temp.
25.5°C
Runback
Settings
Max Time
RunBack Temp
Runback
Max Time
30 min
Runback
Temp
22°C min
Runback
30
Minutes
Runback
22
.5°C
set temp
TIME
Setback Config
OFF
ON
Settings
Runback
Setback Temp.
17°C
Runback
TIME
set temp
17°C
Setback
Runback Config
Setback
Max. Temp.
Runback
Runback Config.
OFF
ON
Settings
Runback
Temperature
Time
Runback ON, Setback OFF,
Max Temp OFF
Runback
Set point
Initial room Temperature
Heating End
Heating Start
Min radiator
Temp (7ºC)
Temp Range available to User
SETBACK
As well as being the
temperature the towel
operates in after Runback
has ended, the setback
setting is used to limit the
lowest temperature that
the towel rail can be set to
while running Runback.
This temperature can be
set between 7°C (minimum)
and 0.5°C less than the
Runback temperature set-
point.
When Setback is
operational, the screen will
show “Setback” and the set-
point.
MAX TEMPERATURE
The Max Temperature
setting allows you to set a
temperature higher than the
Runback temperature
Both the Setback and Max
temp are set with the +/-
buttons from their respective
menus, using Mode/OK
button to enter the desired
mode.
The graphs below show
typical scenarios for each of the settings.
When Setback and Max temp is OFF, the user
has a choice between the minimum towel rail
temperature of 7°C and the Runback temp setting.
Outside of the Runback period the temperature
will fall as low as 7°C if the towel rail is not re-
activated.
ACTIVATING RUNBACK MODE
Runback mode is activated
from the Advanced settings
menu.
The main Runback screen
has 3 options:
• Runback Config
• Setback Config
• Max Temp
Set Runback to ON to
activate the mode.
Note: The Runback settings menu is not
available unless the Runback mode has been
turned on.
The Default time for
Runback to operate is
30 minutes, this can
be increased in ½ hour
incriments up to 8 hours
(480 mins) by using the +/-
buttons and confirming by
pressing Mode/OK .
0 → 30 → 60 → 90 → 120
→ 150 → 180 → 210 → 240
→ 270 → 300 → 330 → 360
→ 390 → 420 → 450 → 480
→0
Select one of the above values, this is how
long Runback will operate for before the Setback
temperature operates. If Setback isn’t activated
then Runback will restart.
After the Runback has expired the next activation
will start at the previous time selected. i.e. If the
previous setting was 60min, the next activation
will start at 60min.
The temperature that
the towel rail runs at when
Runback is activated is
set in the Runback Temp
menu. Use +/- to set the
temperature and press
Mode/OK to confirm.
Please note that the
Runback temperature
cannot be set higher than
the Comfort setting in the
main menu.