19
Set Up
Dust cover fitting
1.
Slot both hinges (2) into the housings (3) in the back of the turntable.
2.
Uniformly push the right and left dust cover (1) receptacles onto the hinges
Connection to Amplifier
The turntable comes with a built-in phono pre-amplifier. It can be either connected to the phono input or the line input at the amplifier.
The built-in phono stage can switched on or off via a switch in the back of the turntable.
Phono-Input
1.
Connect the RCA cable to
the Audio output „AUDIO OUT” (2) at the turntable
and the PHONO input sockets at the amplifier.
2.
Move the switch (1) into the position: PHONO.
3.
Connect the ground connection GND (3) with the amplifier to avoid noise.
Note:
Ensure the correct connection of the cable.
(red = right channel, white = left channel)
Line-Input
1.
Connect the RCA cable to the Audio output „AUDIO OUT” (2) at the turntable
and the LINE / AUX input sockets at the amplifier.
2.
Move the switch (1) into the position: LINE.
3.
Connect the ground connection GND (3) with the amplifier to avoid noise.
Note:
Ensure the correct connection of the cable.
(red = right channel, white = left channel)
Connection to Power Supply
Different adapter plugs (1) are included with the product. Find the specific adapter
relevant to your country and socket system. Fit it to the power supply (2).
1.
Fit the socket adapter into the power supply and twist in the direction
of the arrow (A).
2.
Check that the adapter is locked correctly (B).
3.
Plug the power supply into a power socket (C).
Note:
Only use a factory supplied or approved power supply.
Damage to the turntable!
Incorrect voltages can damage the product. Ensure that the
mains voltage is within the stated specification.
C
