dtm GO801/1001, Assembly Manual

Page: 4 / 12

2
SAFETY INTHEUSEOFTHEAUTOMATIONSYSTEM
Non-observance and non-compliance with the notes in this manual may lead to an accident,
resulting in personal injury or material damage. Please read the following warnings carefully.The gate drive
ensures correct and safe operation only if the installation and use comply with the following safety rules.
DTM System is not responsible for accidents caused by improper use or unprofessional installation of
devices.
·
During the operation of the automation system, both children and adults must keep a safe distance
from the operating automation.
·
The automation system can only be operated by properly trained adults.
·
Control devices should be kept out of the reach of children in order to protect the automation
system against accidental activation.
·
Movement between the gate leaves is allowed only when it is fully open.
·
Do not obstruct the gate movement.
·
Remove any obstacles that impede the movement of the gate.
·
Signal lamps and information boards must be clearly visible.
·
Manual operation of the gate is possible only when the power supply is disconnected and the gate is
unlocked.
·
In the event of a failure, disconnect the power, release the gate to allow access, and then call the
service center for necessary repairs.
·
Do not attempt to repair or maintain the system yourself. The system may only be serviced by
qualified personnel.
·
At least every 6 months, the operation of the automation system, protection devices and protective
circuits should be checked by qualified personnel.
·
Make sure that the persons who install, maintain or operate the gate automation follow these
instructions. Keep these instructions in a place where you can refer to them quickly when needed.