dtm FX510e, User Manual

Page: 2 / 32

Notices
The information in this document is subject to change without notice.
No warranty of any kind is made with regard to this
material, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. No
liability is assumed for errors contained herein or for incidental or consequential damages in connection with the furnishing,
performance, or use of this material. This document contains proprietary information that is protected by copyright. All rights
are reserved. No part of this document may be photocopied, reproduced, or translated into another language without prior
written consent.
Trademark Acknowledgements
Windows is a registered trademark of Microsoft Corporation. All other trademarks are the property of their respective owners.
Printing History
Edition 1.0, #190305, Copyright 2019, DTM Print GmbH. All rights reserved.
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a CLASS A digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications. Operation
of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct
the interference at own expense.
EMS and EMI Compliance Statement
This equipment has been tested and passed with the requirements relating to electromagnetic compatibility based on the
standards EN 55022:1998+A1:2000+A2:2003, CISPR 22 , Class A EN 55024:1998+A1:2001+A2:2003,
IEC 61000- 4 Series EN 61000-3-2 / 2000 & EN 61000-3-3 / 1995. The equipment also tested and passed in accordance with
the European Standard EN55022 for the both Radiated and Conducted emissions limits.
Caution
»
Danger of explosion if battery is incorrectly replaced
» Replace only with the equivalent type recommended by the manufacturer.
»
Dispose of used batteries according to the manufacturer’s instructions.
» Only use with designated power supply adapter model.
»
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s au-
thority to operate the equipment.
Safety Instructions
Please read the following instructions carefully
» Keep the equipment away from humidity.
»
Before you connect the equipment to the power outlet, please check the voltage of the power source.
» Make sure the printer is off before plugging the power connector into the power jack.
»
It is recommended that you connect the printer to a surge protector to prevent possible transient over voltage damage.
» Be careful not to get liquid on the equipment to avoid electrical shock.
»
For safety and warranty reasons, ONLY qualified service personnel should open the equipment.
» Do not repair or adjust energized equipment under any circumstances.