DTM System RIVAL 434, Operating Manual

Page: 7 / 36

2. Receiver’s installation:
- Open Rival 434 enclosure (take off top part - fig.3). Access to receiver power supply terminal, channel terminals 1,2,3,4 and antenna terminal
is direct.
- Mount bottom part of enclosure, use mounting openings (fig.3 element 2). Enclosure mounting should enable wires connection from the
bottom. Depends on instalation (surface or inside) right weakenings of enclosure should be taken out (fig.3 element 1 or 7), wires should be
connected through resulting openings.
- Connect control wires and power supply
- Mount wires through clip to hold them (fig.3 elements 3 and 5) to secure from rip
- Turn on power supply and program receiver according to needs, see operating manual next chapter
- Connect antenna to " " signed terminal. If antenna's range is not enough use outdoor aerial right for 433MHz (not included in set). In case
outdoor aerial mounting use right wire (ex. RG58) according to aerial producer instructions.
- Mount the top case-side back.
4
Fig. 3 Rival 434 enclosure look
3
4
5
1
2
6
7
8
39 mm
102 mm
Legend:
1. weakening for wires in bottom part of enclosure (inside
instalation),
2. weakenings for receiver mounting,
3. clip to hold wire,
4. chamber for electric plate,
5. wire clip clousure,
6. distance sleeve for plate mounting
uk³adu elektronicznego (screw 2,2 x 6,5),
7. weakening for wires in top part of enclosure (surface
instalation),
8. case closing openings,